2023 Hiniker Agricultural Nitro-Lert™ Base

2023 Hiniker Agricultural Nitro-Lert™

The Hiniker Nitro-Lert anhydrous ammonia knife monitor system alerts operators to individual blocked manifold outlets, lines or knives. In-line sensors for each outlet monitor for flow variations and alert the operator to potential problems.

A user-friendly in-cab monitor panel displays the status of up to 80 individual outlets. If a malfunction is detected, an audible alarm is sounded and the display indicates which line is blocked. The operator then has the choice of correcting or ignoring the problem.

The Nitro-Lert system works independently of any other monitor or rate control systems that may be installed. Factory-issued installation guidelines should be followed to assure optimum performance with your particular set-up.

• Nitro-Lert detects plugged knives that occur when the operator turns off the flow to one section of the applicator. When the section is turned back on, the operator can see if one of the knives is plugged with dirt, blocking flow and triggering a Nitro-Lert notification.

• Broken knives. Nitro-Lert detects a variation in flow through the broken knives and alerts the operator of the problem.

• Nitro-Lert detects partial blockage caused by welding slag that could be left in the knife tubes during the manufacturing process.

NITRO-LERT ALERTS THE OPERATOR:

• When a knife is plugged or partially blocked.

• When a blown or loose line causes excessive flow to a knife

• When a manifold outlet is plugged or partially blocked.

• In-cab bar graph display constantly monitors each manifold outlet.

• Audible alarm alerts operator of malfunction.

• User-friendly interface.